|
Hi Nathan,
I installed the build today. I also completed rebuilding my CHR-3 with changed body and offset brackets...
I also changed what IO pins I was using to talk to SSC-32... I rebuilt and am having problems with the XBEES (Hserial 2) no longer talking. So I rebuilt with more debug stuff turned on and my debug output stuff is coming out gibberish.
So I downloaded my simple dump the Port table program that simply does a lot of hserouts. It starts off with:
SetHSerial1 H38400,H8DATABITS,HNOPARITY,H1STOPBITS
hserout 1, [13, 13, "Print Processor Port Table", 13]
I connected terminal 3 in the IDE up to Com14 and 38400 and it also was bad. So I hooked up the Logic analyzer to pins 2 and 4 of the Arc32 JP5 (UART) and captured what was output. I setup the analyzer at 38400 and it also did not like the output. I then let it do an autobaud and it choose the baud rate of 50000 and properly identified the characters that I output.
Kurt
|
Login
Register
FAQ
