BasicMicro - Forums

BasicAtom40 software release version 5.3.1.0.

After the programming is terminated I get the Message “Error verifying 0043FE “
Und I can’t program my Atom40.
Even not a 3 line Program. Always the same Error.
Dos this mean that one EEprom location is bad?
Do I have to return it, or is there a way to use the atom without this location?
Or didn’t I understand something?

At the beginning, when my program was small it was o.k.
When my program gets bigger, I got this error message.
I have no idea what it exactly means and what I can do about it ???
Heinz
PS
When I put an Atom 24 in the same hardware, I can program it without problems.

Hschwenk
Sounds like a problem with the Atom itself. Perhaps the you can return the unit and have it
replaced. I had a similar problem a few years ago.

Hope you solve this problem, good luck.